SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 310 (BODY CONTROL SYSTEM)REPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2011 Cadillac Escalade Base, AWD

Removal Procedure

2011 Cadillac Escalade Base, AWDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION in Cautions and Notices.
  1. Disconnect the negative battery cable(s).
  2. Remove the knee bolster. Refer to KNEE BOLSTER REPLACEMENT in Instrument Panel, Gages, and Console.
    Fig 1: Removing Knee Bolster
    G01458006Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the brown connector.
  4. Disconnect all other connectors (1).
  5. Remove the BCM from the sliding bracket.
    Fig 2: Disconnect Connectors And Removing BCM From Sliding Bracket
    G01458007Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.