SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 244 (BODY CONTROL SYSTEM)REPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2011 Cadillac Escalade Base, AWD

Removal Procedure

2011 Cadillac Escalade Base, AWDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side knee bolster trim panel. Refer to KNEE BOLSTER REPLACEMENT - RIGHT .
    Fig 1: Removing Right Side Knee Bolster Trim Panel
    G02422571Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connectors (2) from the Body Control Module (BCM) (1).
    Fig 2: Disconnecting BCM Electrical Connectors
    G02422572Courtesy of GENERAL MOTORS CORP.
  3. Release the tabs (2) retaining the BCM (1) to the bracket.
  4. Remove the BCM (1) from the vehicle.
    Fig 3: Removing BCM
    G02422573Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.