SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1617 (CONFIGURABLE CUSTOMER CONTROL SYSTEM)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT
2011 Cadillac Escalade Base, AWD

Steering Wheel Control Switch Assembly Replacement

2011 Cadillac Escalade Base, AWDSECTION Steering Wheel Control Switch Assembly Replacement
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel Control Switch Assembly
GM1704178Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to SIR Warning .

Preliminary Procedure

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the horn switch. Refer to Steering Wheel Horn Switch Replacement .
1 Steering Wheel Trim Cover (Qty: 2)
Procedure: 
Remove the 4 horn contact screws.
2 Steering Wheel Control Switch Assembly Screw (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tip:  Quantity may vary with vehicle options.

Tighten:  1 N.m (9 lb in)
3 Steering Wheel Control Switch Assembly (Qty: 2)
Tip: 
  • Quantity may vary with vehicle options.
  • Ensure the steering wheel control switch(es) are properly seated to the steering wheel shroud during installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.