Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1106 (OBJECT DETECTION SYSTEM)
2011 Cadillac Escalade Base, AWD
Section 1106 (Object Detection System)
2011 Cadillac Escalade Base, AWDSECTION Section 1106 (Object Detection System)
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Object Detection
- DTC B0099
- DTC B009A
- DTC B009B
- DTC B009C
- DTC B009D
- DTC B0958, B0959, B0960, or B0961
- DTC B0968
- DTC B1008
- DTC B1015
- DTC B1E3A
- Symptoms - Object Detection
- Information Center Telltale Malfunction
- Pedestrian Impact Detection System Disabling and Enabling
- Repair Instructions
- Pedestrian Impact Detection Sensor Replacement - Front Upper Beam
- Pedestrian Impact Detection Sensor Replacement - Rear Upper Beam
- Active Hood Hinge Actuator Replacement
- Pedestrian Impact Detection Module Replacement
- Rear Object Sensor Replacement
- Rear Object Sensor Housing Replacement
- Repairs and Inspections Required After a Collision
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.