Accessory and Liftgate Control Module Replacement

2011 Cadillac Escalade Base, AWDSECTION Accessory and Liftgate Control Module Replacement
Fig 1: Accessory and Liftgate Control Module
GM1725895Courtesy of GENERAL MOTORS CORP.
Accessory and Liftgate Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the body side trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/o E61) , Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/o E61) .
1 Power Liftgate Actuator Module Retainer
Procedure 
Press the retainer to release.
2 Power Liftgate Actuator Module
3 Electrical Connector

Procedure

  1. Disconnect the electrical connector.
  2. If a replacement control module is installed, program the replacement module. Refer to Liftgate Control Module Programming and Setup .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.