2010 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Instrument Panel Compartment Door Lock Cylinder Coding

Fig 1: View Of Lock Cylinder Tumblers
GM2252127Courtesy of GENERAL MOTORS CORP.

The internal lock cylinder only uses 4 of the ten cut positions, 7 through 10. The tumbler positions are on one side and self-retaining.

  1. Rotate the cylinder (1) so the side with tumbler spring wells faces up.
  2. Insert the tumbler springs (2) into the 4 spring wells.
  3. Install the first tumbler (3) for key cut position 7 in the slot nearest to the front of the lock cylinder. Install the remaining tumblers following the key code.
  4. Press the tumblers in place until they are secure.
  5. Check for correct loading of the tumblers by inserting the key into the cylinder. All tumblers should be flush with the lock cylinder body.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.