2007 Cadillac XLR BaseFACTORY OEM SERVICE PROCEDURE

Steering Wheel Control Switch Assembly Replacement

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Steering Wheel Control Switch Assembly Components
GM1820204Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedures

1 Steering Wheel Control Switch Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

2 Steering Wheel Control Harness Retainer Screw (Qty: 2)

Tighten:Β  2 N.m (18 lb in)

3 Steering Wheel Control Harness Retainer
4 Steering Wheel Control Switch Assembly
Tip:Β 
  • Disconnect the electrical connectors.
  • Carefully pull the control switch assembly away from the steering wheel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.