2007 Cadillac XLR BaseFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver Replacement

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Remote Control Door Lock Receiver Components
GM1883908Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the side door opening frame garnish molding. Refer to Side Door Opening Frame Garnish Molding Replacement .
  2. Remove the body side rear upper garnish molding. Refer to Body Side Rear Upper Garnish Molding Replacement (w/ TB5) or Body Side Rear Upper Garnish Molding Replacement (w/o TB5) .
1 Storage Bin Liner
2 Storage Bin Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:Β  2 N.m (18 lb in)

3 Storage Bin
4 Remote Control Door Lock Receiver

Procedure

  1. The module slides and snaps into the storage bin.
  2. Disconnect the electrical connector.
  3. If a replacement module is installed, program the module. Refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.