2007 Cadillac XLR BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Turn the ignition to OFF.
  2. Remove the instrument panel (I/P) trim pad. Refer to Instrument Panel Trim Pad Replacement .
  3. Fig 1: View Of Remote Control Door Lock Receiver & Screws
    GM1231031Courtesy of GENERAL MOTORS CORP.
  4. Remove the retaining screws from the remote control door lock receiver.
  5. Remove the receiver from the I/P carrier in order to access the wire harness connection.
  6. Disconnect the wire harness connector from the door lock receiver.
  7. Remove the door lock receiver.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.