Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Information on Lack of Communication with Memory Seat Control Module After Reprogramming Any Other Control Module (06-08-50-008)
Reference number: 06-08-50-008
Information on Lack of Communication with Memory Seat Control Module After Reprogramming Any Other Control Module
TECHNICAL SERVICE BULLETIN
| Affected Model(s): | 2007 Cadillac Escalade Models; 2007 Chevrolet Suburban Models; 2007 GMC Yukon Models; with Individual Front Seats (Non Bucket Seats) (RPO AN3) |
SERVICE INFORMATION
Technicians may find that after reprogramming any Electronic Control Unit (ECU) on these vehicles, the Memory Seat Control Module (MSM) may appear to be unable to communicate with the Tech 2(R). However the MSM is fully functional. To restore the ability to communicate with the Tech 2, the MSM must be allowed to go to sleep and then awaken. Perform the following steps before attempting to check and clear any Diagnostic Trouble Codes (DTCs) that may have been set as a result of the reprogramming process.
- After the ECU reprogramming process is complete, rotate the ignition switch to the OFF position.
- Open the driver's door and wait 60 seconds.
- Rotate the ignition switch to the RUN position.
- Clear any DTCs that may have been set during the reprogramming process before returning the vehicle to the customer.
These steps will give the Memory Seat Control Module time to reset and to properly respond to the Tech 2.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
