2006 Cadillac XLR VFACTORY OEM SERVICE PROCEDURE

Instrument Panel Module (IPM)

WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Steering Wheel Controls Return

The scan tool displays the number of counts corresponding to the signal of the switch pressed.

Battery Voltage Signal

The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Accessory, Run, or Run/Crank Relay Status

The scan tool displays the status of the respective relay.

Start, Accessory, or OFF LED Duty Cycle

The scan tool displays the percentage of the pulse width modulation (PWM) control signal of the respective LED.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.