Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Cadillac XLR VFACTORY OEM SERVICE PROCEDURE
Rear Integration Module (RIM) - C2
WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Computer/Integrating Systems Connector End Views
Connector Part Information
|
Terminal Part Information
|
Rear Integration Module (RIM) - C2
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1 | - | - | Not Used |
| 2 | PK | 1339 | Run/Crank Ignition 1 Voltage |
| 3 | YE/BK | 1334 | Left Rear Turn Signal Lamp Supply Voltage |
| 4 | - | - | Not Used |
| 5 | L-BU | 2380 | Rear Parking Assist Chime Signal |
| 6-8 | - | - | Not Used |
| 9 | YE | 5530 | Hood Open Switch Signal |
| 10 | GY | 112 | Windshield Wiper Switch Low/Pulse Signal (Export) (UA2) |
| 11 | YE | 5058 | Intrusion Sensor Armed Signal (Export) (UA2) |
| 12 | TN/BK | 5168 | Power Sounder Enable Signal (Export) (UA2) |
| 13 | D-GN/WH | 1335 | Right Rear Turn Signal Lamp Supply Voltage |
| 14 | PU | 5531 | Hood Closed Switch Signal |
| 15-16 | - | - | Not Used |
| 17 | D-BU/WH | 149 | Courtesy Lamp Supply Voltage |
| 18 | - | - | Not Used |
| 19 | OG/BK | 744 | Trunk Ajar Switch Signal |
| 20 | PU | 5059 | Intrusion Sensor Alarm On Signal (Export) (UA2) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
