Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Cadillac XLR VFACTORY OEM SERVICE PROCEDURE
Instrument Panel Module (IPM) - C2
WARNING: This page is about a different car, the 2006 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Computer/Integrating Systems Connector End Views
Connector Part Information
|
Terminal Part Information
|
Instrument Panel Module (IPM) - C2
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1 | BN | 4 | Accessory Voltage |
| 2 | YE | 6847 | Shift Select Switch Park Supply Voltage |
| 3 | D-GN/WH | 1317 | Fog Lamp Relay Control |
| 4 | TN/WH | 1969 | Headlamp High Beam Relay Control (w/o TT6/TT7/TT8) |
| 4 | TN/WH | 1969 | Headlamp High Beam Relay Control (TT6) |
| 4 | TN/WH | 1969 | Headlamp High Beam Relay Control (TT7/TT8) |
| 5 | WH | 1080 | Park Lamp Relay Control |
| 6 | PK/WH | 1970 | Headlamp Low Beam Relay Control |
| 7 | OG | 300 | Run Ignition 3 Voltage |
| 8 | - | - | Not Used |
| 9 | TN | 28 | Horn Relay Control |
| 10 | TN | 28 | Horn Relay Control |
| 11 | GY | 478 | Windshield Wiper Switch Signal (2) |
| 12 | BN | 253 | Trunk Release Relay Control |
| 13 | GY | 2096 | Steering Column Tilt and Telescope Up Switch Signal |
| 14 | YE | 2097 | Steering Column Tilt and Telescope Down Switch Signal |
| 15 | D-BU | 6856 | Headlamp Automatic High Beam Dim Enable (TQ5) |
| 16 | WH | 5741 | Steering Column Lock Module Lock Enable Relay Control (UA2) |
| 17-18 | - | - | Not Used |
| 19 | D-GN/WH | 1932 | Shift Select Switch Park Signal |
| 20 | WH | 1538 | Headlamp On With Wipers Signal |
| 21 | PK | 2094 | Steering Column Tilt and Telescope Forward Switch Signal |
| 22 | OG | 2095 | Steering Column Tilt and Telescope Rearward Switch Signal |
| 23 | D-GN | 1399 | RAP Relay Coil Supply Voltage |
| 24 | WH | 2282 | Headlamp Washer Relay Control (TT6/TT7/TT8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
