2006 Cadillac STS AWD V6-3.6L VIN 7FACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Service and Repair



ENGINE COOLANT TEMPERATURE SENSOR REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Allow sufficient time for the engine to cool before removing the ECT sensor. A hot engine may cause an excessive coolant loss or a personal injury.

Factory service manual diagram



1. Turn the ignition OFF.
2. Remove the front compartment sight shields as necessary.
3. Disconnect the engine coolant temperature (ECT) sensor electrical connector.

Factory service manual diagram



4. Remove the coolant temperature sensor.

INSTALLATION PROCEDURE

Factory service manual diagram




1. Install the coolant temperature sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the coolant temperature sensor to 22 N.m (16 lb ft).

Factory service manual diagram



2. Install the coolant temperature sensor electrical connector.
3. Inspect and fill the cooling system as necessary. Refer to Draining and Filling Cooling System (Static Fill) Draining and Filling Cooling System (GE 47719) in Cooling System. Service and Repair
4. Install the front compartment sight shields as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.