2005 Cadillac XLRFACTORY OEM SERVICE PROCEDURE

Tool Required

J 34730-1A  Fuel Pressure Gage. See Special Tools .

CAUTION: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.
  1. Turn the ignition OFF.
    CAUTION: Refer to the Battery Disconnect Caution in Cautions and Notices.
  2. Disconnect the negative battery cable in order to avoid possible fuel discharge if an accidental attempt is made to start the engine.
  3. Loosen the fuel filler cap in order to relieve the fuel tank vapor pressure.
  4. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.
    5. Fig 1: Identifying Fuel Pressure Gauge J 34730-1A
    GM180378Courtesy of GENERAL MOTORS CORP.
  5. Connect the J 34730-1A  to the fuel pressure connection. See Special Tools . Wrap a shop towel around the fitting while connecting the gage in order to avoid spillage.
  6. Install the bleed hose of the gage into an approved container.
  7. Open the valve on the gage to bleed the system pressure. The fuel connections are now safe for servicing.
  8. Drain any fuel remaining in the gage into an approved container.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.