Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the new IAC valve O-ring.
- Install the IAC valve (1) into the throttle body.
- Install the IAC valve attaching screws (2) into the IAC valve.
Tighten: Tighten the IAC valve attaching screws to 3 N.m (27 lb. in.).
- Install the electrical connector (1) into the idle air control valve (4).
- The powertrain control module (PCM) will reset the idle air control valve whenever the ignition switch is turned ON, then OFF.
- Turn the ignition switch ON.
- Turn the ignition switch OFF.
- Perform the IAC Valve learn procedure.
IAC Valve Learn Procedure
- Start and idle the engine for 15 seconds.
- Turn the ignition switch to the LOCK/OFF position.
- Wait 15 seconds.
- Restart the engine, and check for proper idle operation.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.