Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Engine Cooling Torque Specifications
ENGINE COOLING TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Coolant Crossover Bolt (8.1L) | 37 (50) | |
| Coolant Heater | ||
| 4.8L, 5.3L & 6.0L | 37 (50) | |
| 8.1L | 40 (60) | |
| Engine Block Coolant Drain Plug | 44 (60) | |
| Fan Clutch Bolt | 17 (23) | |
| Fan Clutch Nut | 41 (56) | |
| Generator Bracket Stud | 15 (20) | |
| Oil Cooler Hose Bracket Bolt (6.0L) | 18 (25) | |
| Oil Pan Skid Plate Bolt | 15 (20) | |
| Radiator Bolt | 18 (25) | |
| Water Outlet Bolt (8.1L) | 22 (30) | |
| Water Pump Bolt (4.8L, 5.3L & 6.0L) | ||
| First Pass | 11 (15) | |
| Final Pass | 22 (30) | |
| Water Pump Bolt (8.1L) | 37 (50) | |
| Water Pump Inlet Bolt | 11 (15) | |
| INCH Lbs. (N.m) | ||
| Air Cleaner Outlet Duct Clamp Screw (4.8L, 5.3L & 6.0L) | 62 (7) | |
| Coolant Air Bleed Pipe Stud/Bolt (4.8L, 5.3L & 6.0L) | 106 (12) | |
| Coolant Heater Cord Bolt | 71 (8) | |
| Fan Shroud Bolt | 80 (9) | |
| Oil Cooler Hose Adapter Bolt (6.0L) | 106 (12) | |
| Surge Tank Bolt/Nut | 80 (9) | |
| Transmission Control Module (TCM) Cover Bolt | 80 (9) | |
| Transmission Control Module (TCM) Electrical Connector Bolt | 71 (8) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.