Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Method 2-Scan Tool Required, Program Individual Transmitter
Only use this option if you are certain which transmitter #1-#4 is being replaced, or the new transmitter can be programmed into a previously unused position within the PDM memory. Refer to IMPORTANT above.
- Install a scan tool.
- Turn the ignition ON, with the engine OFF.
- Use the scan tool in order to access the passenger door module Special Function menu.
- Select "Program Individual Key Fob" to program a specific transmitters.
- Follow the directions on the scan tool in order to program the transmitter or transmitters.
- Operate the transmitter functions in order to verify correct system operation.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.