Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Installation Procedure
IMPORTANT:
Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
- Install the EBCM (2) on to the BPMV (1).
- Install the four new screws in the EBCM (2).
Tighten:Β Tighten the four screws to 5 N.m (39 lb in) in an X-pattern.
- Install or tighten three EHCU bracket mounting bolts (4).
Tighten:Β Tighten the EHCU bracket mounting bolts to 25 N.m (18 lb ft).
- Connect the electrical connectors to the EBCM (1).
- Lower the vehicle.
- Connect the negative battery cable.
- Revise the tire calibration using the Scan Tool Tire Size Calibration function.
- Return to Diagnostic Starting Point - Antilock Brake SystemΒ .
IMPORTANT:
Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
