2004 Cadillac DeVille BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Remove the rear compartment trim panel. Refer to Compartment Side Trim Replacement - RH Rear in Body Rear End.
  2. Fig 1: View Of Fuel Sender Access Panel & Bolts
    GM32756Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel sender access panel bolts.
  4. Remove the fuel sender access panel.
  5. Fig 2: View Of Fuel Tank Pressure Sensor & Electrical Connector
    GM18839Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the fuel tank pressure sensor electrical connector.
  7. Remove the fuel tank pressure sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.