2003 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing RIM
    GM650999Courtesy of GENERAL MOTORS CORP.
  1. Install the RIM (1) to the electrical component mounting panel.
  2. Push the RIM (1) into the opening on the electrical component mounting panel, until an audible click is heard, indicating the Rim (1) is secured to the electrical component mounting panel.
  3. Connect the electrical connections to the RIM (1).
  4. Fig 2: View Of Rear Integration Module Mounting Bracket & Fasteners
    GM625727Courtesy of GENERAL MOTORS CORP.
  5. Install the electrical component mounting panel (1) to the vehicle body.
  6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the electrical component mounting panel nuts (2).

    Tighten:Β  Tighten the nuts (2) to 9 N.m (80 lb in).

  8. Install the rear storage compartment trim. Refer to Compartment Trim Panel Replacement - Rear in Body Rear End.
  9. Restore the drivers personalization settings. Refer to Driver Personalization in Personalization.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.