2003 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Proper DIM Placement
    GM509428Courtesy of GENERAL MOTORS CORP.
  1. Install the module to the bracket.
  2. Slide the DIM upward until it is fully engaged.
  3. Fig 2: View Of DIM Module & Electrical Connectors
    GM488279Courtesy of GENERAL MOTORS CORP.
  4. Connect the DIM electrical connectors (2).
  5. Install the right sound insulator. Refer to Closeout/Insulator Panel Replacement - Right (LHD) or Closeout/Insulator Panel Replacement - Right (RHD) in Instrument Panel, Gages and Console.
  6. Reprogram the Dash Integration Module. Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM)Β  or Body Control Module (BCM) Programming/RPO Configuration (DIM)Β .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.