2003 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install the memory seat module (4) to the seat cushion frame.
  2. Install the new rivets (3) to the memory seat module (4) in order to secure the memory seat module to the seat cushion frame.
    Fig 1: Locating Memory Seat Module Rivets
    G02180334Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the memory seat module.
  4. Connect the heated seat cushion cover electrical connectors and the wire hold down clips which were removed during disassembly.
    Fig 2: Connecting Electrical Connector To Memory Seat Module
    G02180335Courtesy of GENERAL MOTORS CORP.
  5. Remove the protective cover from the seat riser.
  6. Install the seat cushion assembly (1) to the seat riser.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. Install the fasteners (2) to the seat cushion assembly (1).
    Fig 3: Installing Fasteners To Seat Cushion Assembly
    G02180336Courtesy of GENERAL MOTORS CORP.
  8. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly
  9. Install the front seat cushion assembly rear fasteners (1) to the seat cushion assembly.

    Tighten 

    Tighten the seat cushion assembly fasteners to 9 N.m (80 lb in).

  10. Angle the front seat cushion up, in order to access the front seat cushion assembly fasteners.

    Tighten 

    Tighten the seat cushion assembly fasteners to 9 N.m (80 lb in).

    Fig 4: Locating Front Seat Cushion Assembly Rear Fasteners
    G02180337Courtesy of GENERAL MOTORS CORP.
  11. Enable the SIR System. Refer to ZONE 7 or ZONE 9 in Air Bag Restraint Systems.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.