Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
ABS Component Views
WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Brake Pressure Modulator Valve (BPMV) |
| 2 | Brake Fluid Pressure Sensor |
| 3 | Brake Fluid Pressure Sensor Connector |
| 4 | Wheel Speed Sensor (WSS) - LR (RR Similar) |
| 5 | Wheel Speed Sensor (WSS) Connector - LR (RR Similar) |
| 6 | Parking Brake Cable |
| 7 | Brake Rotor - LR (RR Similar) |
| 8 | Wheel Speed Sensor (WSS) Connector - LF (RF Similar) |
| 9 | Wheel Speed Sensor (WSS) - LF (RF Similar) |
| 10 | Brake Rotor - LF (RF Similar) |
| 11 | Electronic Brake Control Module (EBCM) |
| 12 | EBCM Connector Lock |
| 13 | EBCM Connector |
| 14 | EBCM Connector Position Assurance Retainer |
| Callout | Component Name |
|---|---|
| 1 | Accelerator Pedal Position (APP) Sensor |
| 2 | Accelerator Pedal |
| 3 | Brake Pedal |
| 4 | Brake Pedal Position (BPP) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Accelerator Pedal Position (APP) Sensor Connector |
| 2 | Accelerator Pedal Position (APP) Sensor |
| 3 | Steering Wheel Position Sensor |
| Callout | Component Name |
|---|---|
| 1 | Traction Control Switch Connector |
| 2 | Traction Control Switch |
| 3 | Glove Box |
| Callout | Component Name |
|---|---|
| 1 | Shift Control Assembly Connector |
| 2 | Body Harness Ground G306 |
| 3 | Yaw Rate and Lateral Acceleration Sensor Connector |
| 4 | Yaw Rate and Lateral Acceleration Sensor |
| 5 | Inflatable Restraint Sensing and Diagnostic Module (SDM) Connector |
| 6 | Inflatable Restraint Sensing and Diagnostic Module (SDM) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
