Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Procedure to Set Up a Rear Integration Module (RIM)
WARNING: This page is about a different car, the 2003 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure the scan tool has been updated with the latest software version.
- Ensure the battery is fully charged.
- Ensure all modules on the serial data line are connected.
- Connect a scan tool to the data link connector (DLC).
- Turn ON the ignition, with the engine OFF.
- Under the dash integration module (DIM) main menu, select Special Functions. Under the Special Functions menu, one of the choices is Set Options.
- Under the Set Options menu, the user selects from the following as available:
- GM Trap Alert, to continue with the procedure follow the scan tool on screen instructions to deactivate GM Trap Alert.
- Intrusion Sensor Part A, to continue with the procedure follow the scan tool on screen instructions to select the intrusion sensor.
- Intrusion Sensor Part B, to continue with the procedure follow the scan tool on screen instructions to select the intrusion sensor.
- Inclination Sensor Part A, to continue with the procedure follow the scan tool on screen instructions to select the inclination sensor.
- Inclination Sensor Part B, to continue with the procedure follow the scan tool on screen instructions to select the inclination sensor.
- Alarm Siren Module Part A, to continue with the procedure follow the scan tool on screen instructions to select the alarm siren module.
- Alarm Siren Module Part B, to continue with the procedure follow the scan tool on screen instructions to select the alarm siren module.
- Exit, to go back to Special Functions menu.
- Cycle the ignition key OFF for 5 seconds, then ON to complete the procedure.
Important: After programming, perform the following to avoid future misdiagnosis:
- Turn the ignition OFF for 10 seconds.
- Connect the scan tool to the data link connector.
- Turn the ignition ON with the engine OFF.
- Use the scan tool in order to retrieve history DTCs from all modules.
- Clear all history DTCs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.