Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2003 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Install the TV module (1) to the rear shelf.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the fasteners securing the TV module to the rear shelf.
Tighten

Tighten the fasteners to 9 N.m (80 lb in).

Fig 1: Installing Fasteners & TV Module To Rear Shelf
Courtesy of GENERAL MOTORS CORP.
Connect the coax cables (3) to the TV module.

Fig 2: Connecting Coax Cables To TV Module
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector (1).
Reinstall the rear shelf. Refer to TRIM PANEL REPLACEMENT -- REAR WINDOW SHELF in Interior Trim.

Fig 3: Connecting Electrical Connector
Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: TV Antenna Module Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.