2003 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the module into the vehicle.
  2. Connect the lower electrical harness connectors (2).
  3. Fig 1: View Of Memory Seat Control Module & Lower Electrical Harness Connectors
    GM914892Courtesy of GENERAL MOTORS CORP.
  4. Slide the module (2) to the left to engage the lower retainers.
  5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the module retaining screws (3).

    Tighten:Β  Tighten the screws to 3 N.m (26 lb in).

  7. Connect the upper electrical harness connectors (3).
  8. Fig 2: View Of Memory Seat Control Module Retaining Screws & Upper Electrical Harness Connector
    GM914889Courtesy of GENERAL MOTORS CORP.
  9. Install the seat cushion. Refer to Seat Cushion Frame Replacement - FrontΒ .
  10. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration ProcedureΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.