Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Cadillac DeVille BaseFACTORY OEM SERVICE PROCEDURE
Section 249 (Tire Pressure Monitoring System)
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Schematic And Routing Diagrams
- Diagnostic Information And Procedures
- Diagnostic Starting Point - Tire Pressure Monitoring
- Diagnostic System Check - Tire Pressure Monitoring
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B2818: BCM Detects Ground Signal From Reset Switch
- DTC C1245: EBCM Detects Tire Pressure Difference In One Tire
- Symptoms - Tire Pressure Monitoring
- Low Tire Pressure Indicator Always On
- Low Tire Pressure Indicator Inoperative
- Low Tire Pressure Indicator Does Not Reset
- Repair Instructions
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
