2003 Cadillac CTS AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G100 On engine block, near starter motor. See Figure.
G101 Near left front strut tower, at bottom of inside fenderwell. See Figure.
G102 On engine block, near generator. See Figure.
G104 On right body rail, near right headlamp. See Figure.
G105 On inner fender wall, near battery. See Figure.
G107 On engine, near ignition coils. See Figure.
G110 On right frame rail, near ABS module. See Figure.
G200 In passenger compartment, behind the left kick pad. See Figure.
G201 In passenger compartment, behind the right kick pad. See Figure.
G303 On right "C" pillar. See Figure.
G304 On the rear package shelf, left of subwoofer. See Figure.
G306 On left "C" pillar. See Figure.
G307 In passenger compartment, to left of driver's seat. See Figure.
G401 Rear of right rear shock tower. See Figure.
G402 Rear of left rear shock tower. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.