2003 Cadillac CTS AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Connect the lateral accelerometer sensor electrical connector.
  2. Install the lateral accelerometer sensor (2) to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the lateral accelerometer sensor mounting nuts (1) to the mounting studs.

    Tighten 

    Tighten the lateral accelerometer sensor mounting nuts to 9 N.m (80 lb in).

  4. Install the center console to the vehicle. Refer to CONSOLE REPLACEMENT -- FRONT FLOOR in Instrument Panel, Gages, and Console.
  5. Perform the ABS Diagnostic System Check. Refer to DIAGNOSTIC SYSTEM CHECK - ABS .
    Fig 1: Lateral Accelerometer Sensor Mounting Nuts
    G02088103Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.