Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Turn OFF the ignition.
Important:Β
The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of dissembled ABS components.
- Thoroughly clean all of the contaminants from and around the EBCM assembly.
Important:Β It is not necessary to drain the coolant or disconnect the coolant lines when moving the coolant bypass valve.
- Disconnect the coolant bypass valve from the radiator and position out of the way. Refer to COOLANT BYPASS VALVE REPLACEMENT in Engine Cooling.
- Remove the EBCM connector position assurance retainer (4) from the EBCM electrical connector (1).
- Rotate the EBCM connector tab (2) up to the unlocked position.
- Disconnect the EBCM electrical connector (1) from the EBCM (3).
- Remove and discard the 2 upper EBCM to brake pressure modulator valve (BPMV) screws (1).
- Raise and suitably support the vehicle. Refer to JACKING AND LIFTING in General Information.
- Remove the front air deflector. Refer to AIR DEFLECTOR REPLACEMENT -- FRONT in Body Front End.
- Remove and discard the 2 lower EBCM to brake pressure modulator valve (BPMV) screws (1).
- Lower the vehicle.
- Clean the surface of the EBCM/BPMV assembly.
Important:Β The EBCM cannot be repaired. If faulty, the unit must be replaced.
- Separate the EBCM (1) from the BPMV (2).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
