Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Cadillac Seville STSFACTORY OEM SERVICE PROCEDURE
Rear Integration Module: Removal
NOTE:
Before replacing the RIM, record the personalization settings in order to restore the settings after the new module is installed.
- Remove the rear storage compartment trim.
- Remove the bay board fasteners (2). See Fig 1 .
- Pull the bay board (1) away from the body and place the bay board (1) module side up in the rear compartment. See Fig 1 .
- Disconnect the electrical connections from the RIM.
- Remove the RIM (1) by depressing the locking tabs (2) inward, in order to release the RIM (1) from the bay board. See Fig 2 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.