Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Cadillac Seville STSFACTORY OEM SERVICE PROCEDURE
Tilt/Telescoping Soft Stop Programming Procedure
- Turn ignition to ON, leaving the engine off.
- To set the tilt up soft stop, press the tilt/telescoping COLUMN UP switch at least eight times or until the column moves, then release the switch.
- Press the tilt/telescoping COLUMN UP switch and hold the switch until the column travels all the way up, and continue to hold the switch about a second after motion stops at the mechanical end of travel. The soft stop for the column up position is now set. The tilt/telescoping module automatically goes back to the normal mode of operation.
- Repeat steps 2 and 3, using the COLUMN DOWN switch, to set the column down position soft stop.
- Repeat steps 2 and 3, using the COLUMN IN switch, to set the column in position soft stop.
- Repeat steps 2 and 3, using the COLUMN OUT switch, to set the column out position soft stop.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
