Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Dash Integration Module: Removal

NOTE: Before replacing the DIM, record the personalization settings in order to restore the settings after the new module is installed.

Remove the right sound insulator (hush panel under dash).
Disconnect the DIM (1) electrical connectors (2). See Fig 1 .
Depress inward on the locking tab (2). See Fig 2 .
With the locking tab (2) depressed, slide the DIM (1) downward. See Fig 2 .
Remove the DIM from the bracket.

Fig 1: Identifying DIM Harness Connectors

Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: Dash Integration Module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.