Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
- Remove the engine protection shield, if equipped.
- Remove the steering damper from the relay rod, if equipped. Refer to Steering Damper Replacement .
Important: Use the proper tool in order to separate all the tie rod and the ball joints.
- Remove the tie rod ends (6). Refer to Tie Rod Replacement .
- Remove the idler arm ball stud nut (10). Do not reuse the nut.
- Remove the pitman arm nut (8). Do not reuse the nut.
- Remove the relay rod from the idler arm ball stud using the J 24319-B .
- Remove the relay rod from the pitman arm ball stud using the J 24319-B .
- Remove the relay rod from the vehicle.
- Inspect the threads on the tie rod ends for damage.
- Inspect the ball stud threads for damage.
- Inspect the ball stud seals for excessive damage.
- Clean the threads on the ball studs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
