2002 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Important:Β  The daytime running light (DRL) module is on the left knee bolster bracket to the left of the steering column. You can reach the module from under the steering column.

  1. Remove the instrument panel driver knee bolster panel. TRIM PANEL REPLACEMENT - KNEE BOLSTER
  2. Disconnect the electrical connector from the DRL module.
  3. Remove the DRL module (4) from the left outside knee bolster bracket (1).
    Fig 1: Removing DRL Module From Left Outside Knee Bolster Bracket
    G01736171Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.