2002 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the jounce bumper to the mounting cup. Use the 4WD 15-series and, the 2WD 25/35-series supplies.
    Fig 1: Snap Jounce Bumper To Mounting Cup
    G01480096Courtesy of GENERAL MOTORS CORP.
  2. Install the jounce bumper. Use the 4WD 15-series and, the 2WD 25/35-series supplies.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the nut to the jounce bumper stud.

    Tighten 

    Tighten the nut to 30 N.m (22 lb ft).

  4. Remove the safety stands.
  5. Lower the vehicle.
  6. Fig 2: Install Nut To Jounce Bumper Stud
    G01480097Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.