2002 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. Perform Alternative Fuels Diagnostic System Check - Engine Controls. See ALTERNATIVE FUELS DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article. After performing Alternative Fuels Diagnostic System Check - Engine Controls, go to next step.
  2. Did you perform Fuel Injector Coil Test? If yes, go to next step. If no, go to FUEL INJECTOR COIL TEST (BI-FUEL & CNG)Β .
  3. Start and idle engine. Observe Fuel Rail Pressure (FRP) sensor parameter with scan tool. Is fuel pressure within 40-50 psi (275-345 kPa)? If yes, go to next step. If no, go to FUEL SYSTEM DIAGNOSIS (BI-FUEL & CNG)Β .
  4. Turn OFF the ignition. Turn ON the ignition, with the engine OFF. Monitor Fuel Rail Pressure (FRP) sensor parameter with scan tool. Does fuel rail pressure remain constant? If yes, go to next step. If no, go to FUEL SYSTEM DIAGNOSIS (BI-FUEL & CNG)Β .
  5. CAUTION: DO NOT repeat any portion of this test before running engine in order to prevent engine from flooding.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.