Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Cadillac Escalade EXTFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the jumper harnesses to the EBCM
- Install the EBCM and jumper harnesses to the vehicle.NOTE:
- Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
- Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
- Install the EBCM (2) on to the BPMV (1).
- Install the four new screws in the EBCM (2). Tighten the four screws to 5 N.m (39 lbs in) in an X-pattern.
- Connect the brake fluid pressure sensor (7) and pressure accumulator switch (4) electrical connectors.
- Lower the vehicle.
- Connect the negative battery cable.
- Revise the tire calibration using the Scan Tool Tire Size Calibration function.
- Return to Diagnostic Starting Point - Anti-lock Brake System .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.