2002 Cadillac DeVille BaseFACTORY OEM SERVICE PROCEDURE

Shift Control Assembly (Console Shift): Removal

  1. Set the parking brake, then shift the vehicle into neutral in order to allow clearance for the console trim plate to be removed.
  2. NOTE: To prevent component damage, do not use metal tools to remove the trim.
  3. Using a thin bladed tool or a hook tool, pry upward on the rear edge of the console trim plate in order to disengage 4 of the 6 clips retaining the trim plate.
  4. Lift the rear of the trim plate in order to disconnect the traction control switch electrical connector. See Figure .
  5. Push down lightly on the front of the console trim plate and pull towards the rear in order to avoid interference with the storage compartment door trim when disengaging the front console trim panel clips.
  6. Lift the console trim plate over the shift handle and remove the console trim plate. See Figure . Unsnap the shift cable terminal from the shifter pin. See Figure .
  7. Disconnect the A/T shift interlock solenoid wire harness connector. Remove the shifter fasteners, and remove the shifter assembly. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.