Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Cadillac Seville STSFACTORY OEM SERVICE PROCEDURE
Rear Integration Module: Installation
- Install the RIM to the bay board.
- Push the RIM (1) into the opening on the bay board, until an audible click is heard, indicating the Rim (1) is secured to the bay board. See Fig 1 .
- Connect the electrical connections to the RIM.
- Install the bay board to the vehicle body.
- Install the bay board fasteners (2). See Figure . Tighten the fasteners (2) to 80 INCH lbs. (9 N.m).
- Install the rear storage compartment trim.
- Reprogram the RIM. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
- Restore the drivers personalization settings.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.