If replacing a Powertrain Control Module (PCM) with a replacement part, after programming, these modules will learn incoming fuel continue password immediately upon receipt of a password message. Once a password message is received and a password is learned, a learn procedure must be performed to change this password again. A PCM which has been previously installed in another vehicle will have learned the other vehicle's fuel continue password and will require a learn procedure after programming to learn current vehicle's password.

Turn ignition on. Attempt to start engine, then release key to ON position (vehicle will not start). Observe SECURITY indicator. After about 10 minutes, SECURITY indicator will turn off. Turn ignition off and wait 5 seconds.
Repeat step 1 2 more times for a total of 3 cycles in 30 minutes. Vehicle is now ready to relearn key transponder information and/or passwords on next ignition switch transition from OFF to CRANK position.

NOTE: Vehicle learns key transponder information and/or password on next ignition switch transition from OFF to CRANK position. Ignition switch must be turned to OFF position before attempting to start vehicle.

Start engine. Vehicle has now learned the key transponder information and the PCM has now learned the fuel continue password. Using scan tool, clear any DTCs if needed.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Programming Theft Deterrent System Components

Use the Manual With the Right Hardware

When to See a Mechanic