Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0602: Control Module Not PROGRAMED: Description
Powertrain Control Module (PCM) uses an Electrically Erasable Programmable Read Only Memory (EEPROM) to store software and calibration information. EEPROM is not replaceable, PCM must be replaced. Replacement PCM does not contain final program information. Replacement PCM must be programed. If replacement PCM is not programmed, DTC P0602 will set. When DTC sets, PCM disables fuel pump relay and fuel injectors.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.