Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Using Tech 2 Scan Tool
NOTE:
This procedure is written strictly for Tech 2 scan tool. A generic scan tool may be used, but may have limited capabilities.
To enter programming using Tech 2, perform these following steps:
- Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, near steering column.
- Turn ignition switch to RUN position.
- Select correct vehicle and model year.
- Select body.
- Select personalization.
- Select set options.
- Select Driver #1 memory recall or Driver #2 memory recall.
- Select on of these options: auto exit driver seat, key in IGN recall driver seat, remote entry recall driver seat, recall exit on RKE unlock.
- Press ENTER to turn option on or off. (An asterisk appears next to current options).
- Exit from menu.
- Select DRIVER #1 auto exit seat or DRIVER #2 auto exit seat.
- Highlight auto exit seat and press ENTER button to turn selection on or off. (An asterisk appears next to feature turned on.).
- Exit from menu.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
