2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Programming Using Driver's Information Center

To enter programming using Driver's Information Center (DIC), perform these following actions:

  1. Turn ignition switch to RUN position.
  2. Place transmission in Park.
  3. Press MEMORY SET 1 or 2 button, depending on driver.
  4. Press INFO button. DIC will display FEATURE PROGRAMMING.
  5. Press ON/OFF button to enter programming mode.
  6. DIC displays Driver #1 or Driver #2, depending on chosen driver for programming.
  7. Press INFO button up or down to scroll through feature choices.
  8. Press ON/OFF button to turn one of these options on or off (only one choice can be ON at any given time): REMOTE RECALL MEMORY or KEY IN RECALL MEMORY.
  9. Press INFO button to advance to next feature.
  10. DIC displays AUTO EXIT SEAT.
  11. Press ON/OFF button to turn this feature on or off.
  12. Press INFO button to advance to next feature.
  13. DIC displays AUTO EXIT STRG WHEEL.
  14. Press ON/OFF button to turn this feature on or off.
  15. Press INFO button to advance to next feature.
  16. To exit programming mode, press INFO RESET button.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.