2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Using Scan Tool

NOTE: Procedure is written specifically for use with GM Tech I or Tech II scan tools. Generic scan tool can be used but may have limited functions.

To enter programming, perform these steps:

  1. Connect scan tool to Data Link Connector (DLC).
  2. Turn ignition switch to RUN position.
  3. Select current vehicle and model year.
  4. Select body.
  5. Select personalization.
  6. Select set options.
  7. Select Driver #1 Curb View or Driver #2 Curb View.
  8. Highlight Parallel Park Assist and press ENTER button to turn feature ON or OFF. An asterisk appears when feature is turned on.
  9. Exit from menu.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.