Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Programming Using GM Tech 2
- Connect scan tool to Data Link Connector (DLC).
- Turn ignition switch to RUN position.
- Using scan tool, select REMOTE FUNCTION ACTUATION special function. Program remote transmitters to place RCDLR into program mode. Doors will lock and unlock to confirm program mode.
- Press and hold LOCK and UNLOCK buttons simultaneously on first remote transmitter. After a 15 second delay, doors will lock and unlock to confirm programming of remote transmitter.
- Repeat previous step to program up to 4 remote transmitters.
- Remove scan tool.
- Operate remote transmitter functions to verify system operation.
NOTE:
Scan tool must stay connected until all remote transmitters are programmed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
