Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Programming Using Driver's Information Center
To enter programming mode with Driver's Information Center (DIC), perform these actions:
- Turn ignition switch to RUN position.
- Place vehicle in Park.
- Press MEMORY seat button 1 or 2 depending on driver for personalization programming.
- Press INFO button on DIC until FEATURE PROGRAMMING is displayed.
- Press ON/OFF button to enter programming mode.
- DIC will display DRIVER #1 or DRIVER #2, depending on chosen driver for personalization programming.
- Press INFO button up or down to scroll through feature choices.
- DIC displays LIGHTS FLASH AT UNLOCK.
- Press ON/OFF button to turn this feature on or off.
- Press INFO button to advance to next option.
- DIC displays LIGHTS FLASH AT LOCK.
- Press ON/OFF button to turn this feature on or off.
- Press INFO button to advance to next option.
- DIC displays HORN SOUNDS AT LOCK.
- Press ON/OFF button to turn this feature on or off.
- Press ON/OFF button to advance to next option.
- DIC displays EXT LIGHTS AT LOCK.
- Press ON/OFF button to turn this feature on or off.
- Press INFO button to advance to next option.
- To exit programming mode, press INFO RESET button on DIC.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
