2001 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Programming Using GM Tech 2

To enter programming, perform these steps:

  1. Connect scan tool to Data Link Connector (DLC).
  2. Turn ignition switch to RUN position.
  3. Select current vehicle and model year.
  4. Select body.
  5. Select personalization.
  6. Select set options.
  7. Select DRIVER #1 automatic door lock mode or DRIVER #2 automatic door lock mode.
  8. Highlight desired mode from Mode 0-5.
  9. Exit menu.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.