Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Adding Keys Procedure
You may add up to 10 additional master keys or valet keys using this procedure when a learned master key is available. This procedure adds keys only and does not erase previously learned keys. Keys to be learned must duplicate mechanical cut of current key. If more than one valet key is to be learned, immediately precede each valet key with a learned master key.
With a previously learned master key, turn ignition switch to RUN position. with engine off. Turn ignition switch to OFF position and remove key. Within 10 seconds insert key to be learned. Turn ignition switch to RUN position. with engine off. Vehicle has now learned new key.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
